Community-sourced DIY repair guides for the 2001–2012 GMC Sierra HD, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Controller and plugs are stocked at dealers and parts stores; module replacement needs only basic hand tools.
Typical difficulty: Easy — based on 70 code guides for the glow repair area (an area-level estimate, not this exact job).
Torque specs
Glow plug installation: verify — Look up the factory torque before installing; over-torquing snaps plugs in the head.
Tips
Glow plug faults on LBZ-through-LML trucks (2006-2016) usually trace to one of four places: the glow plug control module, an individual glow plug, the wiring harness, or a combination. Common codes are P0380 (glow plug circuit A), P0382 (circuit B), and P0671-P0678 for individual cylinders.
The module sits at the top rear of the driver's side of the engine. The quick owner test: with the key on during the wait-to-start cycle, probe the glow plug rail with a test light. No power at the rail means the module is likely bad; power at the rail means chase individual plugs or wiring instead.
Do not ignore a glow plug fault just because the truck starts fine. A failed controller can over-cycle a glow plug or feed current to a dead one continuously, which swells the plug tip. A swollen tip is very hard to remove and risks dropping the tip into the cylinder.
On California-emissions trucks (YF5/NE1 codes in the glove box), a single failed glow plug will set P0380; federal-emissions trucks need several to fail before the code appears. Know which emissions package you have before diagnosing.
Replacement controllers are inexpensive and easy to swap (owners report under $150 and a short driveway job). Use ACDelco 9G glow plugs for LBZ, LMM, and LML trucks; they supersede the older 61G and are not compatible with 2004-2005 LLY engines.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2001–2012 GMC Sierra HD yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.