Community-sourced DIY repair guides for the 2018–2018 Dodge Journey, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer-only repair; you just need to know the symptom and your build date. The dealer bleeds the brake system (and verifies the calipers) at no charge.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
Brake system fasteners: verify — Confirm against factory service info for the Journey before torquing.
Tips
The signature symptom is a low or soft brake pedal — insufficient coating on the rear brake caliper pistons lets gas pockets form in the fluid, reducing rear brake performance. Do not pay for a brake job to chase this first: it is a factory defect with a free factory fix.
The recall only covers 2018 Journeys built March 17, 2018 through June 21, 2018 (MDH 031706 through 062101). Check your door-jamb build date before calling — if yours falls outside that window, a soft pedal has a different cause.
The remedy is a dealer brake-system bleed, free of charge (FCA campaign U86, NHTSA 18V-523, began September 29, 2018, ~154,000 vehicles across the affected models).
Call FCA customer service at 1-800-853-1403 with your VIN to confirm coverage; have it checked before spending money on master cylinders or boosters for the same symptom.
Dealer-only repair — the PCM is replaced, not repaired. If your 2018 Journey stalls or cranks without starting, check this recall by VIN before paying for sensors or pumps.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
PCM/module fasteners: verify — No owner-serviceable torque values for a dealer PCM replacement; confirm against factory service info if a module is ever removed.
Tips
The PCM circuit board may carry a suspect voltage-regulator chip. When it fails you get a no-start, a start-then-immediate-stall, or an engine stall while driving — with no prior warning. Do not replace crank sensors, fuel pumps, or ignition parts to chase this first.
This is a documented free route: dealers replace the powertrain control module free of charge (FCA campaign U87, NHTSA 18V-524, recall began October 2, 2018, 12,779 vehicles).
Applies to 2018 Journeys (also covers other 2018 FCA models); the dealer identifies affected PCMs by sales code — the service instructions specifically added 2.4L sales codes ED6/ED8.
Check by VIN with FCA customer service at 1-800-853-1403; an unrepaired vehicle in this group can stall at any time.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2018–2018 Dodge Journey yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.