Turn signal blinking fast — the burned-out bulb telegram

You signal a turn and the dashboard arrow blinks fast — double-time — on one side, while the other side blinks normally. This isn't a flasher problem: the car's flasher relay is designed to blink fast when a bulb is out, because the electrical load changed. It's a built-in bulb-out warning, and it's almost always right.

Most likely causes, in check-order

Cheapest and easiest first. Don't buy parts until the checks below point at one.

1. A burned-out turn signal bulb

Front or rear, the usual answer. The fast blink is the car's way of pointing at the dead one — walk around and look while the signal runs.

2. A bulb that's loose or corroded in its socket

A bulb that works intermittently — fast blink sometimes, normal others — is usually a corroded socket or a bulb not seated. Wiggle it and watch.

3. Wrong replacement bulb installed

LED or wrong-wattage bulbs change the circuit load, and the flasher reads that as a bulb out. If the fast blink started right after a bulb change, the bulb is the story.

4. Damaged socket or wiring

Melted plastic, green corrosion, or a wire rubbed through at the lamp housing. If new bulbs keep dying in the same socket, the socket is the problem.

5. Trailer wiring or a tow harness fault

On trucks with trailer wiring, a corroded trailer connector can load the circuit wrong and fast-blink a perfectly good bulb.

Driveway checks

Related