Cruise control not working — won't engage, or cuts out on its own

You press SET and nothing happens — or it engages, then disengages itself a minute later, sometimes with a dashboard light. Cruise control is a committee decision: the car needs a steady speed signal, confirmation the brakes aren't applied, and a working throttle. If any committee member goes silent, cruise quits rather than guess. The good news: the committee is small and the usual deserter is cheap.

Most likely causes, in check-order

Cheapest and easiest first. Don't buy parts until the checks below point at one.

1. Failed brake light switch

The most common cause by a wide margin. Cruise needs to know the brake pedal is released; a failing switch sends a phantom 'braking' signal and cruise refuses to engage or cuts out. Check: do the brake lights work normally, and do they ever stick on?

2. Wheel speed sensor fault

Cruise needs a stable speed reading. A flaky wheel-speed sensor makes the speed signal drop out, and cruise disengages. Often arrives with an ABS or traction light — that's the pairing to look for.

3. Blown fuse or bad relay

Cruise dead entirely, no dash indicator at all: check the fuse. A sudden total failure with no other symptoms is the fuse's signature.

4. Clock spring failure

The steering-wheel buttons talk to the car through the clock spring in the column. Cruise buttons dead but everything else works, especially after steering work or with an airbag light on, points here.

5. Throttle or speed-signal codes stored

The computer won't run cruise if it doesn't trust its throttle or speed inputs. Get codes read — a stored throttle or vehicle-speed code explains a cruise refusal even when the buttons are fine.

Related diagnostic codes

P0500 · P0503 · P0562

Driveway checks

Related