Dead key fob? Your car has a backup plan — by make

A dead fob battery feels like a locked-out emergency, but every push-button-start car was designed for it — the manufacturers had to assume the little coin cell would die eventually. There is a backup plan with three parts, and once you have done it once it takes under a minute. The pattern is the same everywhere; only the details move around, which is why this page goes make by make.

The universal pattern

  1. There is a real metal key inside the fob. It is released by a small tab, slider or catch on the fob. It exists for exactly this day.
  2. The door lock is often hidden. Many cars cover the driver's-door key cylinder with part of the handle trim or a small cap. The mechanical key usually both removes the cover and turns the lock under it. Opening the door this way may set the alarm off — starting the car is what silences it.
  3. The fob can be read with no battery at all. Inside the fob is a passive chip that needs no power of its own; the car can read it at very close range. So each make gives the chip a place to be read: held against the start button, held against a marked spot, or dropped into a specific slot or pocket. That placement — not a fresh battery — is what the per-make sections below are about.

Two honest limits: this only works if the car's 12-volt battery is alive (a fob trick cannot fix a dead car — see the won't-start guide and the EV 12-volt guide), and it only works with the fob that belongs to the car. And if your exact model differs from the general procedure for its make, your owner's manual wins — every procedure below ends there anyway.

By make

Each entry below was checked against that maker's owner's-manual or manufacturer procedure. Makes whose procedure could not be verified that way are not listed, rather than guessed at. Lexus and Acura are not listed separately for the same reason — their parent brands' systems are closely related, but check your own manual rather than assuming the Toyota or Honda steps transfer unchanged.

Toyota

Getting in: A mechanical key is built into the Smart Key. Release it from the fob and use it in the driver's door lock to get in.

Starting: Hold the Smart Key right next to the START button and press the button with it while holding the brake. Toyota's own support answer describes exactly this: the key held next to the button lets the engine start even with the fob battery dead.

Honda

Getting in: Slide the release knob on the back of the remote and pull out the built-in key. Honda's owner's guide says this key locks and unlocks the doors when the remote battery is weak and power locks are disabled.

Starting: When the car displays the hold-remote message: touch the centre of the ENGINE START/STOP button with the logo side of the remote, buttons facing you, while the button's indicator is flashing. Then, with the brake depressed, press the button promptly — Honda's guide gives a window of about 10 seconds after the beeper sounds and the indicator changes from flashing to on.

Ford

Getting in: The key is hidden inside the fob — work the tab on the back and remove the back cover to find it. On many models the door lock is covered: insert the key into the small hole on the underside of the driver's door handle, press up, and slide the cover off to reveal the lock cylinder.

Starting: Ford uses a backup slot rather than the button itself, and its location genuinely varies by model and year: inside the centre console on several cars (fob in the fob-shaped slot), and under a front cupholder liner on recent F-150s. This is the one make where you should find your model's slot in the owner's manual before you need it — then put the fob in the slot, hold the brake, and start as normal.

GM (Chevrolet / GMC)

Getting in: An emergency key is stored in the fob (released at the bottom of the fob on many models). Use it in the key cylinder on the driver's door.

Starting: Follow the dash prompt: when the car says no remote is detected, it tells you to place the transmitter in the transmitter pocket. On models like the Silverado and Traverse that pocket is inside the centre console, fob buttons facing up; on models like the Equinox, Malibu and Tahoe the pocket is in a front cupholder. Put the fob in the pocket for your model, hold the brake, and press ENGINE START/STOP.

Nissan

Getting in: The Intelligent Key contains a mechanical key — slide the release tab and pull it out, then use it in the door's key cylinder.

Starting: Touch the ignition switch with the Intelligent Key itself. A chime sounds; within 10 seconds of the chime, press the ignition switch while depressing the brake pedal, per Nissan's own Intelligent Key instructions.

Hyundai

Getting in: Press the release on the fob and pull out the mechanical key. On many models the keyhole is hidden under the small cap beside the driver's door handle — remove the cap to use it.

Starting: The dash will prompt you: press the start button with the key. Hold the brake and press the ENGINE START/STOP button using the top of the fob itself, so the fob is touching the button as it is pressed.

Kia

Getting in: The smart key carries a mechanical key for the driver's door; on many models a cap on the door handle covers the cylinder and comes off first.

Starting: Kia's owner's manual is specific about orientation: press the ENGINE START/STOP button directly with the smart key, with the side of the fob carrying the lock button contacting the button directly, at a right angle, while you hold the brake.

Volkswagen

Getting in: The fob contains an emergency key blade. The driver's door lock is typically under a cover on the handle — remove the cover and unlock manually.

Starting: Hold the fob against the marked reader spot on the right side of the steering column (where a key cylinder would sit on an older car) while you hold the brake and press the start button. Owners quoting the manual describe the same steering-column spot across Golf and Tiguan models; if your model marks a different spot, the marking is a key symbol — look for it.

Audi

Getting in: Press the catch on the fob to release the mechanical key, and use it to unlock the driver's door (the lock may sit under a handle cover).

Starting: The car tells you what to do: the dash message says to hold the back of the key against the designated area and refers you to the owner's manual. That area varies by model — a marked spot on the steering column or centre console on some, and the front cupholder (marked with a key symbol) on the Q5. Hold the back of the fob flat against it and start as normal.

BMW

Getting in: An integrated metal key slides out of the fob when you press its release. The driver's-door keyhole is concealed — behind or under part of the door-handle trim on many models.

Starting: Hold the remote control flat against the key marking on the steering column — BMW's dash message phrases it as holding the remote control on the steering column, and BMW's service information describes the same emergency-start check. With the fob held there, press the start button with the brake depressed.

Mazda

Getting in: The transmitter contains an auxiliary key, released from the fob. Mazda's Smart Start Guide says to use the auxiliary key to lock or unlock the doors if the key battery is dead.

Starting: Mazda's sequence has a tell: press the brake (or clutch), and the indicator in the push-button start flashes green. While it flashes, touch the back side of the transmitter to the START/STOP button; the indicator stops flashing and stays lit. Then press the button with your finger to start.

Jeep (Stellantis)

Getting in: The fob carries a mechanical key for the driver's door — release it from the fob and unlock manually.

Starting: Jeep's owner's manual wording is about the nose of the fob: put the nose side (the end opposite the key ring) of the key fob against the START/STOP button and push the button with the fob to operate the ignition switch.

The battery itself: buy the right coin cell

Most fobs run on a coin cell, and two sizes cover a large share of cars: CR2032 and CR2025. Both are 20 mm across and 3 volts; the last two digits are the thickness — 3.2 mm versus 2.5 mm — so a CR2032 often will not fit a fob designed for the thinner CR2025, and the thinner cell can sit loose in a CR2032 fob. Do not guess: the size is stamped on the old cell, and your owner's manual lists it.

Typical fob-battery life is roughly two to five years, shorter on fobs that are used constantly or stored close enough to the car to keep talking to it. The cheap fix for this entire page is a calendar habit: replace the fob battery on a schedule — every couple of years, or at the first sign of shrinking range or a low-key-battery warning — instead of waiting for the morning it dies in an airport car park. Keep the spare cell in the house, not in the car it unlocks.

If it still won't start

  • Alarm sounding, dash dark, nothing electrical works: that is the car's 12-volt battery, not the fob. See first-freeze checks if it is a cold morning.
  • Dash alive, "key not detected" even with the fob in the backup spot: move phones and laptops away from the fob (manufacturers warn they can block detection), try the second fob, and replace the fob battery before assuming anything worse.
  • Worked yesterday with a new fob battery, dead again today: the cell may be in backwards, a stale cell, or the fob itself may be damaged — that is a dealer or locksmith conversation, and the Fix Index can help you sanity-check what you are quoted.

Related: what to do after a 12-volt battery replacement, and why cold mornings light up your dash.