Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe car derates boost and EGR on backup values - fix it before it cascades into DPF problems.
Exhaust pressure sensor C is reading wrong. The computer uses exhaust pressure to manage the turbo, EGR, and DPF - so one bad sensor ripples everywhere.
Key facts
P2E57 means exhaust Pressure Sensor C Circuit High. Exhaust pressure sensor C is reading wrong. The computer uses exhaust pressure to manage the turbo, EGR, and DPF - so one bad sensor ripples everywhere. WrenchFair's published fair-price range for this repair is $80–$250 parts and $100–$250 labor at independent shops.
WrenchFair rates P2E57 a 2-of-5 DIY difficulty (“Cleaning a soot-choked pressure tube fixes most of these; the sensor swap is one bolt.”) with a “Diagnose soon” driveability rating: The car derates boost and EGR on backup values - fix it before it cascades into DPF problems. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
reduced boost or power
dpf regen issues
sensor reading stuck or erratic
Likely causes
Soot-blocked pressure tube (most common)
Failed pressure sensor
Heat-damaged wiring
Corroded connector
signal wire shorted to B+
open sensor
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code and log the sensor's reading at idle and under load.
Remove and inspect the sensor's pressure tube - soot blockage is the classic cause. Tests: Soot-blocked pressure tube (most common)
Clean or replace the blocked tube, then retest before replacing the sensor. Tests: Soot-blocked pressure tube (most common)
Check the sensor wiring for heat damage. Tests: Heat-damaged wiring
Replace the sensor if the tube is clear and the reading is still wrong.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$80 – $250
Labor$100 – $250
Exhaust pressure sensor replacement and pressure tube cleaning. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2E57 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Cleaning a soot-choked pressure tube fixes most of these; the sensor swap is one bolt.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →