P2D37

P2D37: Hybrid/EV Battery Inductive Charger Input Circuit Range/Performance

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car can charge wirelessly over a pad, and that inductive charging system is reporting a fault. Plug-in charging usually still works fine.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. High-voltage safety first: this code lives in the high-voltage system, which can carry lethal voltage. Only touch it if you are trained and equipped for HV service (insulated tools, HV gloves, service-plug procedure); everyone else should stop at scanning and hand the repair to a qualified EV/hybrid technician. Tests: High-voltage interlock loop fault
  2. Scan the inductive charging module and record the exact sub-faults - input, output, interlock, or processor. Tests: Inductive charger control module internal fault
  3. Check pad alignment and remove any foreign objects or debris between the pads. Tests: Charge pad misalignment or foreign object on the pad (most common)
  4. Try a known-good charge pad or a different parking position to rule out the ground side.
  5. Inspect the vehicle charge pad, its wiring, and the HV interlock loop for damage.
  6. If the module reports internal or processor faults, check for software updates before replacing the module.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$600 – $2500
Labor$300 – $700

Inductive charger control module replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2D37 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Basic checks are easy, but the system is high-voltage and module-level faults need dealer-level tools.

Watch this repair on YouTube

Parts & tools

Battery & charging toolkit — what the job actually takes

Torque specs: Terminal clamps: snug, typically 5–8 Nm. Over-tightening cracks the battery post.

Pro tip: Disconnect negative first, reconnect negative last. On module-heavy cars use a memory saver so you don’t lose radio codes and adaptations.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →