P2164

P2164: Throttle pedal position sensor B maximum stop performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The computer is seeing an incorrect voltage from throttle/pedal sensor B at the wide-open throttle end of travel - it cannot trust the signal at full throttle.

Model notes: Some manufacturers require the throttle body, throttle actuator motor, and all throttle position sensors to be replaced as a single unit.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle matching the symptoms and codes.
  2. Visually inspect all system-related wiring and connectors. Tests: Corroded electrical connectors
  3. Check the throttle plate for signs of carbon buildup or damage - clean the throttle body per manufacturer recommendations. Tests: Carbon buildup on the throttle plate
  4. Retrieve all stored codes and freeze-frame data; clear codes and test drive.
  5. Watch the scanner data stream for voltage spikes and inconsistencies between the TPS, PPS, and PCM.
  6. Use a DVOM on the sensor signal wires - observe voltage while slowly actuating the throttle from closed to wide open; look for spikes (typically about 0.5 volts closed to 4.5 volts at WOT, but check specs).
  7. If the sensor checks out, test individual circuits with the DVOM using wiring diagrams.
  8. Suspect a defective PCM only after all sensors and circuits check out.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $600
Labor$100 – $400

Throttle body assembly or pedal position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2164 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Inspecting wiring and cleaning the throttle body are DIY-friendly; live sensor signal testing with a multimeter is intermediate.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →