P2136: Throttle pedal position sensor switch A C voltage correlation
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonLoss of throttle control can leave you with no acceleration or a stuck throttle - do not drive in this condition.
The throttle sensors A and C disagree with each other - your car's computer cannot confirm the actual throttle position.
Key facts
P2136 means throttle pedal position sensor switch A C voltage correlation. The throttle sensors A and C disagree with each other - your car's computer cannot confirm the actual throttle position. WrenchFair's published fair-price range for this repair is $20–$500 parts and $100–$400 labor at independent shops.
WrenchFair rates P2136 a 4-of-5 DIY difficulty (“Inspecting and cleaning the throttle body connector is DIY-friendly; throttle body replacement is moderate work on many vehicles.”) with a “Diagnose soon” driveability rating: Loss of throttle control can leave you with no acceleration or a stuck throttle - do not drive in this condition. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
engine power reduced / limp mode
stalling when coming to a stop
total lack of power or no acceleration
sudden loss of power at cruise speeds
throttle stuck at current rpm
Likely causes
Poor connection in the throttle body wiring connector (corroded or pulled-out pigtail terminals)
Bare wire on the throttle body pigtail shorted to ground
Distorted throttle body top cover preventing the gears from turning properly
Faulty electronic throttle body
Failed accelerator pedal sensor or its wiring
Engine management computer failure (less likely)
Throttle relearn not performed after a repair
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 8 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your vehicle relating to this code.
Check for a manufacturer throttle relearn procedure and perform it if applicable. Tests: Throttle relearn not performed after a repair
Pull the electrical connector off the throttle body - inspect for missing, bent, or corroded female terminals. Tests: Poor connection in the throttle body wiring connector (corroded or pulled-out pigtail…
Clean any corrosion, apply dielectric grease, and reconnect.
If terminals are bent or missing, replace the pigtail connector.
Inspect the top cover of the throttle body for cracks or warping - replace the throttle body if distorted.
Probe the accelerator pedal sensor - signal voltage should rise smoothly as the pedal is depressed.
Address any additional throttle codes first.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $500
Labor$100 – $400
Pigtail connector repair, accelerator pedal sensor replacement, or throttle body replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2136 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Inspecting and cleaning the throttle body connector is DIY-friendly; throttle body replacement is moderate work on many vehicles.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →