P2131

P2131: Throttle position sensor switch F circuit range performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The third throttle position sensor circuit is reading outside its expected range - the reported throttle angle does not match what the computer expects.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the idle and wide-open-throttle TPS readings with a scan tool against specifications.
  2. If readings are off, replace the TPS and re-check.
  3. Watch the TPS signal on an oscilloscope while sweeping the throttle - it should rise and fall smoothly with no dropouts or spikes.
  4. Perform a wiggle test: wiggle the connector and harness while watching the signal pattern. Tests: Water or corrosion in the connector or sensor
  5. If there is no TPS signal, check for the 5-volt reference at the connector, then check the ground circuit.
  6. Make sure the signal circuit does not have battery voltage - if it does, trace for a short to voltage.
  7. Look for water in the connector.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$80 – $250

Throttle position sensor replacement, wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2131 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Checking TPS readings with a scan tool and inspecting the harness are DIY-friendly; intermittent dropouts need an oscilloscope.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →