P212E

P212E: Throttle Position Sensor/switch G Circuit Intermittent

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The throttle position sensor G signal is cutting in and out intermittently.

Model notes: Applies to Dodge, Chrysler, Hyundai, Jeep, Mazda.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check technical service bulletins for the vehicle and code; TSBs are especially helpful for intermittent conditions.
  2. Begin with a visual inspection of all system-related wiring and connectors; test the throttle plate for carbon coking or damage. Repair or replace defective wiring or components, then recheck the throttle body and TPS. Tests: Open or shorted TPS G wiring or connectors
  3. Connect the scanner, retrieve all stored codes and freeze frame data, write them down, clear the codes, and test-drive. If the code is not reset, the condition may need to worsen before an accurate diagnosis; operate the vehicle normally until the PCM enters readiness mode or the code resets.
  4. Narrow the scanner data stream to pertinent data to spot glitches and inconsistencies in the TPS signal.
  5. If no glitches are detected, use the DVOM connected to the ground and signal circuits to watch live voltage while operating the throttle manually from closed to wide open (typically 0.5 volts closed to 4.5 volts wide open). Glitches or inconsistencies indicate a defective or misadjusted sensor.
  6. If the TPS was recently replaced and P212E persists, consult the vehicle information source for TPS adjustment specs and adjust accurately with the DVOM.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$20 – $120
Labor$50 – $200

Throttle position sensor replacement or adjustment. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P212E ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual wiring inspection is easy; catching intermittent voltage glitches with a DVOM is intermediate; TPS adjustment requires service specs.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →