P2100: Throttle actuator A control motor circuit open
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonUsually severe: the PCM cannot control the throttle, leaving a fixed idle and no acceleration.
The electrical circuit that drives your electronic throttle body motor has an open break - the computer cannot control the throttle.
Key facts
P2100 means throttle actuator A control motor circuit open. The electrical circuit that drives your electronic throttle body motor has an open break - the computer cannot control the throttle. WrenchFair's published fair-price range for this repair is $150–$500 parts and $150–$400 labor at independent shops.
WrenchFair rates P2100 a 4-of-5 DIY difficulty (“Visually inspecting the actuator connector and wiring for corrosion is DIY-friendly; testing actuator resistance and the power/ground circuits needs a multimeter and service info.”) with a “Diagnose soon” driveability rating: Usually severe: the PCM cannot control the throttle, leaving a fixed idle and no acceleration. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
fixed idle speed, usually around 1000-1200 rpm
unable to accelerate the engine
electronic throttle control warning light
limp mode
Likely causes
Open in the circuit to the throttle actuator - wiring break (most common)
Failed throttle actuator - failed open circuit electrically
Bad relay or relay connections
Corroded connector terminals
Failed PCM (unlikely)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your vehicle.
Locate throttle actuator A and visually inspect the connector and wiring - look for scraping, rubbing, bare wires, burn spots, or corrosion. Tests: Open in the circuit to the throttle actuator - wiring break (most common)
Clean corroded terminals with electrical contact cleaner, apply electrical grease, and clear the codes. Tests: Corroded connector terminals
If the code returns, test the actuator motor resistance with the DVOM against manufacturer specifications. Tests: Open in the circuit to the throttle actuator - wiring break (most common)
Check for 12V at the actuator power supply circuit and verify the ground circuit with a test light.
If all tests pass, suspect the wiring from the PCM or relay, or a failed PCM.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$150 – $500
Labor$150 – $400
Throttle actuator / throttle body replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2100 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Visually inspecting the actuator connector and wiring for corrosion is DIY-friendly; testing actuator resistance and the power/ground circuits needs a multimeter and service info.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →