P202F

P202F: Reductant/regeneration Supply Control Circuit Range/performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The diesel exhaust fluid (DEF) supply pump is not responding within its expected range.

Model notes: Diesel vehicles only (Dodge, Chevrolet, GMC, Ford). Frequently attributed to supply pumps drawing excessive voltage.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Retrieve stored codes and freeze frame data, record them, clear the codes, and test-drive until the PCM enters readiness mode or the code resets.
  2. Search a vehicle information source for diagnostic flow-charts, connector pin-out charts, connector face views, and component testing procedures/specifications.
  3. Use the DVOM to test the reductant tank supply pump against manufacturer specifications; components outside maximum allowable parameters are defective. Tests: Defective reductant supply pump (overload)
  4. Test reductant supply pump voltage (usually battery voltage) with the pump activated; if conditions do not permit activation, manually activate the pump with the scan tool. Tests: Defective reductant supply pump (overload)
  5. If the pump is functional, test input and output signal circuits from the fuse panel, PCM, and ignition switch with the DVOM, disconnecting all controllers first.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$200 – $700
Labor$100 – $400

Reductant supply pump replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P202F ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Pump and circuit tests are intermediate; DEF tank/pump access varies.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →