P2011

P2011: Intake manifold runner control circuit open (bank 2)

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

There is a broken wire or dead electrical connection in the circuit that controls the little air-shaping flaps inside your intake on the non-cylinder-1 side. The flaps are probably fine - the computer just cannot talk to their motor or valve. Expect a rough idle, surging, and slightly weaker low-end pull.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your make and model before touching anything.
  2. Inspect the vacuum hoses for cracks and the electrical connector on the solenoid for corrosion or a loose fit. Tests: Corroded or loose electrical connector at the solenoid
  3. With a scan tool, run the solenoid operational test and command it open and closed; if it does not respond, the valve is bad. Tests: Failed IMRC / swirl-flap solenoid valve, heat-soaked and fouled by dirt and EGR soot…
  4. If the valve works but the actuating rod barely moves, the intake manifold flaps are gummed or the manifold needs replacement. Tests: Failed IMRC / swirl-flap solenoid valve, heat-soaked and fouled by dirt and EGR soot…
  5. If the solenoid is dead, test continuity between the harness connector and the fuse/relay feeds with an ohmmeter per the service manual.
  6. If a MAF or EGR code is stored alongside this one, diagnose and repair that code first, then clear and retest.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $600
Labor$120 – $500

IMRC solenoid valve replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2011 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Electrical checks are straightforward, but reaching the solenoid often means working around a hot, crowded intake; check bulletins first since some vehicles have a known reprogram fix.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →