P200B

P200B: Intake manifold runner performance (bank 2)

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The little air-shaping flaps inside your intake are not responding the way the computer expects on the non-cylinder-1 side. They usually fail in the open position, so the car still drives - but you will notice worse mileage, weaker performance, and maybe a stumble at idle.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. If MAF, MAP, or IAT codes are stored alongside, diagnose those first - they corrupt the data the computer uses to judge runner performance. Tests: Bad IMRC position sensor or a MAF/MAP/IAT sensor feeding bad data - fix those codes first…
  2. Check for technical service bulletins for your make and model before touching anything.
  3. Visually inspect the bank 2 IMRC linkage, bushings, vacuum lines and hoses, and electrical connectors; repair worn hardware or collapsed lines first. Tests: Broken or worn IMRC linkage or bushings (most common)
  4. With the key on and engine off, apply vacuum with a hand pump to the actuator and confirm the flaps actually open on request. Tests: Faulty IMRC vacuum supply actuator
  5. If the flaps move, watch scanner data for the IMRC position sensors and test any out-of-spec sensor with a multimeter against the factory specs.
  6. If hardware and sensors check out, test the runner control solenoids against spec; only suspect the computer itself after everything else is ruled out.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $450
Labor$150 – $450

IMRC linkage or actuator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P200B ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The mechanical inspection is easy once you reach the linkage, but full diagnosis needs a scan tool, a multimeter, and a hand vacuum pump for vacuum-operated systems.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →