P2007

P2007: Intake manifold runner control stuck closed (bank 2)

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Inside your intake there are little flaps that shape airflow, and the ones on the non-cylinder-1 side of the engine are stuck shut. The engine will hesitate when you ask for power, run rich, and use more fuel.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your make and model - several have known IMRC fixes.
  2. Inspect the bank 2 IMRC actuator and its connector face for corrosion, bent pins, and damaged wiring. Tests: Corroded IMRC actuator connector face or open/shorted wiring in the solenoid control…
  3. With a scan tool, command the actuator open and watch the runner position sensor feedback to confirm the flaps are not responding. Tests: Bad bank 2 IMRC runner position sensor
  4. Disconnect the actuator from the linkage shaft and move the runner flaps by hand to feel for binding; be careful with the small screws or rivets holding the flaps to the shaft. Tests: Carbon coking on the runner flaps or inside the intake ports binding them shut (most…
  5. If binding, inspect for carbon buildup on the flaps and inside the manifold ports, and for loose or missing flap screws; clean or repair as needed.
  6. If the mechanics move freely, test the actuator solenoid and position sensor resistance against the factory specs, then check circuit continuity with the controllers disconnected to avoid damage.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $400
Labor$150 – $450

Intake cleaning or IMRC actuator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2007 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Reaching the actuator and linkage often means removing intake components; the mechanical binding check itself is straightforward once you have access.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →