P0D67

P0D67: Battery Charger Control Module A Performance

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The battery charger control module isn't doing what the car asked it to do. The car may refuse to charge or stop charging partway; it is usually still drivable on its remaining charge.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Clear the code and confirm it returns under the same conditions before replacing anything.
  2. 2. Inspect the battery charger control module a connector and wiring for damage, corrosion, or loose pins.
  3. 3. Check live data on a scan tool and compare against expected values in the service manual.
  4. 4. Rule out wiring and connector faults before replacing the battery charger control module a; suspect the control module only after the circuit tests good. Tests: internal module fault (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$580 – $3450
Labor$280 – $1440

Internal module fault. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0D67 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — This is a low-voltage signal circuit - diagnosis is multimeter and scan-tool work with no high-voltage exposure.

Watch this repair on YouTube

Parts & tools

Battery & charging toolkit — what the job actually takes

Torque specs: Terminal clamps: snug, typically 5–8 Nm. Over-tightening cracks the battery post.

Pro tip: Disconnect negative first, reconnect negative last. On module-heavy cars use a memory saver so you don’t lose radio codes and adaptations.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →