P0D18: Battery Charging System A High Voltage Interlock Circuit High
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe high-voltage system will not energize with the interlock loop broken - the car usually will not start; tow it in.
The battery charging system high voltage interlock signal is stuck high - think of a wire touching a power feed or a failed sensor. The car may refuse to charge or stop charging partway; it is usually still drivable on its remaining charge.
Key facts
P0D18 means battery Charging System A High Voltage Interlock Circuit High. The battery charging system high voltage interlock signal is stuck high - think of a wire touching a power feed or a failed sensor. The car may refuse to charge or stop charging partway; it is usually still drivable on its remaining charge. WrenchFair's published fair-price range for this repair is $340–$2300 parts and $280–$1080 labor at independent shops.
WrenchFair rates P0D18 a 4-of-5 DIY difficulty (“High-voltage system: lethal voltage in the pack and orange cables - pack and inverter internals are qualified-technician-only work, and DIY is limited to visual checks, fuses, and 12V-side testing.”) with a “Diagnose soon” driveability rating: The high-voltage system will not energize with the interlock loop broken - the car usually will not start; tow it in. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
vehicle will not charge
charging stops partway
charge warning light on
erratic operation of the monitored system
Likely causes
wire shorted to B+ (most common)
pull-down resistor open
connector pins corroded - high contact resistance
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. HIGH-VOLTAGE SAFETY FIRST: this code touches the traction-battery high-voltage system. Lethal voltage lives in the pack and the orange cables - pack internals are qualified-technician-only work. DIY is limited to visual inspection, fuses, and 12V-side checks with the system depowered.
2. Clear the code and confirm it returns under the same conditions before replacing anything.
3. Inspect the battery charging system a high voltage interlock connector and wiring for damage, corrosion, water intrusion, or pins pushed back out of the connector body - pay attention to spots where the harness flexes or rubs. Tests: connector pins corroded - high contact resistance
4. With a scan tool, watch the live battery charging system a high voltage interlock reading while wiggling the harness; a reading that jumps or drops out confirms a wiring or connector fault. Tests: connector pins corroded - high contact resistance
5. Check the battery charging system a high voltage interlock power, ground, and signal wiring for opens and shorts per the factory service manual before condemning the part.
6. If the wiring tests good, replace the battery charging system a high voltage interlock sensor or component, then retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$340 – $2300
Labor$280 – $1080
Repairing the short in the battery charging system a high voltage interlock circuit. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0D18 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — High-voltage system: lethal voltage in the pack and orange cables - pack and inverter internals are qualified-technician-only work, and DIY is limited to visual checks, fuses, and 12V-side testing.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →