Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonDrivable; high crankcase pressure can push oil past seals over time.
A sensor watches the pressure inside your engine's crankcase, and its signal is wrong. Usually the sensor or its wiring failed - but if the engine has a lot of blow-by from worn piston rings, the pressure can genuinely be off, so check that too.
Key facts
P051C means crankcase Pressure Sensor Circuit Low. A sensor watches the pressure inside your engine's crankcase, and its signal is wrong. Usually the sensor or its wiring failed - but if the engine has a lot of blow-by from worn piston rings, the pressure can genuinely be off, so check that too. WrenchFair's published fair-price range for this repair is $40–$150 parts and $75–$200 labor at independent shops.
WrenchFair rates P051C a 2-of-5 DIY difficulty (“Sensor testing plus a basic blow-by sanity check.”) with a “Diagnose soon” driveability rating: Drivable; high crankcase pressure can push oil past seals over time. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
oil leaks from seals
whistling from the oil cap area
Likely causes
failed crankcase pressure sensor
wiring fault
excessive blow-by from worn piston rings
blocked PCV system raising crankcase pressure
corroded connector
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
Watch crankcase pressure with live data and compare with the oil cap removed (pressure should drop). Tests: failed crankcase pressure sensor
Check for excessive blow-by - heavy pulsing from the oil fill suggests worn rings. Tests: excessive blow-by from worn piston rings
Test the sensor circuit.
Suspect the PCM only after every wire and component test passes - module failure is rare.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$75 – $200
Crankcase pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P051C ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Sensor testing plus a basic blow-by sanity check.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →