P046B

P046B: Catalyst Temperature Sensor 1/2 Correlation (Bank 2)

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car has two temperature sensors watching the converter on side 2, and their readings disagree. Usually one sensor is lying, but a damaged converter can also change the temperature pattern.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Scan for all codes and record freeze-frame data, then clear the code and test-drive to see if it returns.
  2. Graph both bank 2 catalyst temperature sensors - the one stuck or reading impossibly is the bad one. Tests: failed catalyst temperature sensor
  3. Inspect wiring for heat damage. Tests: wiring damaged by exhaust heat
  4. Suspect the PCM only after every wire and component test passes - module failure is rare.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $250
Labor$100 – $250

Catalyst temperature sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P046B ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Compare the two sensor readings with live data; replace the one that is wrong.

Watch this repair on YouTube

Parts & tools

Catalytic converter toolkit — what the job actually takes

Torque specs: Exhaust flange nuts: typically 35–50 Nm — verify spec. O2 sensors: typically 35–50 Nm.

Pro tip: A new cat on an engine that’s burning oil or misfiring will die fast — fix the underlying cause first or you’ll be buying another one.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →