Cylinder 12 is misfiring - a bad coil, worn plug, or weak injector is the usual cause.
WrenchFair rates every code on a three-level driveability scale — Drive safe, Diagnose soon, Stop driving — based on what the fault can do if you keep driving. For P0312, the rating comes down to this: If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
These overrule any rating. Pull over safely and stop the engine if:
If the car is behaving normally — no new shaking, noises, or power loss — a careful, gentle drive to a nearby shop is what most people do. Avoid highways and long trips until you know the cause. If any of the tow signs above show up, stop and call a tow instead.
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Short trips and gentle driving only, until you know the cause. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. If the check engine light is flashing, stop driving - raw fuel is cooking the catalytic converter.
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Read the full P0312 guide → Diagnose your code
Got a shop quote? Grade it →