P02CC: Cylinder 1 injector 'A' offset learning at min limit
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonAn uncalibrated injector stresses the engine - address promptly.
Cylinder 1's injector calibration has maxed out - the injector flows too much. It may need replacement and coding.
Model notes: Primarily a diesel common-rail code. Always code new injectors to the ECM.
Key facts
P02CC means cylinder 1 injector 'A' offset learning at min limit. Cylinder 1's injector calibration has maxed out - the injector flows too much. It may need replacement and coding. WrenchFair's published fair-price range for this repair is $150–$700 parts and $150–$500 labor at independent shops.
WrenchFair rates P02CC a 4-of-5 DIY difficulty (“Injector coding needs a scan tool that can write correction values.”) with a “Diagnose soon” driveability rating: An uncalibrated injector stresses the engine - address promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
rough running
smoke
Likely causes
Worn cylinder 1 injector flowing too much (most common)
Wrong injector correction values programmed
New injector not coded to the ECM
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Verify the correct injector part number is installed Tests: Worn cylinder 1 injector flowing too much (most common)
Replace and code the injector if worn Tests: Worn cylinder 1 injector flowing too much (most common)
Run the injector learning procedure after replacement Tests: Worn cylinder 1 injector flowing too much (most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$150 – $700
Labor$150 – $500
Fuel injector replacement and coding (cylinder 1). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P02CC ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Injector coding needs a scan tool that can write correction values.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →