Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonCold-starting difficulty only - but repeated long cranking wears the starter and battery.
The extra fuel injector that helps cold starts has an electrical fault. The car will be hard to start when cold but runs fine once warm.
Model notes: Mostly found on older port-injected vehicles (80s-90s). Modern cars handle cold enrichment through the main injectors.
Key facts
P0213 means cold start injector 1 circuit fault. The extra fuel injector that helps cold starts has an electrical fault. The car will be hard to start when cold but runs fine once warm. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates P0213 a 2-of-5 DIY difficulty (“The injector is usually in the intake plenum and easy to reach.”) with a “Diagnose soon” driveability rating: Cold-starting difficulty only - but repeated long cranking wears the starter and battery. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
hard cold starting
extended cranking when cold
no issues once warm
Likely causes
Failed cold start injector 1 (most common)
Damaged wiring or connector
Open or short in the injector circuit
Failed cold-start thermo-switch (on older systems)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Confirm your vehicle has a cold-start injector Tests: Failed cold start injector 1 (most common)
Check the injector's resistance against factory spec
Use a noid light to verify the ECM pulses it during cold cranking
Inspect the wiring and connector Tests: Damaged wiring or connector
On older systems, test the thermo-time switch that controls it
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $200
Cold start injector replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0213 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — The injector is usually in the intake plenum and easy to reach.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →