P0201-P0208

P0201-P0208: Injector circuit fault, cylinder 1

DIY difficulty 3/5

The fuel injector on one specific cylinder has an electrical problem - not clogged, but electrically dead or shorted. That cylinder gets no fuel, so the engine runs rough.

VW/Audi note (VCDS): Resistance comparison across all injectors is the fastest test - they should all read nearly identical; the outlier is the failed one.
Model notes: Always replace injector O-rings and seals when servicing injectors - reusing hardened seals causes vacuum leaks and fuel odor. Lubricate new O-rings with clean engine oil on installation.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Measure injector winding resistance and compare to spec and to the other injectors - the odd one is bad Tests: Failed injector with open or shorted winding (most common)
  2. Use a noid light to confirm the ECM is sending pulse to that injector Tests: Failed injector with open or shorted winding (most common)
  3. Check the connector and wiring for that cylinder Tests: Damaged wiring or connector at that injector
  4. Replace the injector with new seals; relieve fuel pressure first and work cold Tests: Failed injector with open or shorted winding (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $500
Labor$150 – $500

Wiring or connector repair is most common; injector replacement if the injector tests bad. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

DIY difficulty

3 of 5 — Injector resistance testing is easy; access to the injector and fuel system safety are the real work.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →