P0200

P0200: Injector circuit/open

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

There's an electrical break in the wiring that powers the fuel injectors as a group. The engine may not start or may run very poorly.

VW/Audi note (VCDS): A noid light on an injector connector during cranking instantly shows whether the injector is getting its pulse.
Model notes: A blown injector fuse often has a cause - a shorted injector or chafed harness. Replace the fuse, but find why it blew or it will blow again.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the injector fuse and relay first - this code commonly follows a blown fuse Tests: Blown injector fuse (most common - check first)
  2. Verify battery voltage reaches the injector harness with key on Tests: Blown injector fuse (most common - check first)
  3. Check the shared ground connections Tests: Damaged shared power or ground wiring
  4. If power and ground are good, test individual injector circuits and the ECM driver Tests: ECM injector driver fault (rare)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $500
Labor$150 – $500

Wiring or connector repair is most common; injector replacement if the injector tests bad. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0200 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Shared-circuit faults are often a fuse or relay - the cheap fixes come first.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →