DIY difficulty 2/5
| What it means | Your engine's second bank is running lean - too much air or too little fuel on that side. Usually a vacuum leak in that bank's intake plumbing. |
|---|---|
| Most common cause | Bank 2 intake/vacuum leak |
| Can you drive? | Short trips and gentle driving only, until you know the cause. |
| Severity | Moderate |
| DIY cost (parts only) | $10 – $120 |
| Shop cost (parts + labor) | $110 – $400 |
| DIY difficulty | 2 of 5 — Bank isolation actually narrows the search. |
Short trips and gentle driving only, until you know the cause. Safe to drive to a shop, but diagnose soon - prolonged lean running damages the catalytic converter. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Safe to drive to a shop, but diagnose soon - prolonged lean running damages the catalytic converter.
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Your engine's second bank is running lean - too much air or too little fuel on that side. Usually a vacuum leak in that bank's intake plumbing.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Work these checks before spending money — each one rules a cause in or out, cheapest first.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Usually a bank-specific hose or gasket. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
Got a shop quote? Grade it →
Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.