P0150

P0150: O2 sensor circuit malfunction, bank 2 sensor 1

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Same oxygen-sensor electrical fault as the main one, but on the other side of a V6 or V8 engine. The computer can't meter fuel properly for that side.

VW/Audi note (VCDS): Display both upstream sensors side by side in live data; the faulty bank stands out immediately against the healthy one.
Model notes: On transverse V6 engines the bank 2 (firewall side) upstream sensor is the classic knuckle-buster - soak it with penetrating oil and consider removing adjacent brackets or heat shields for access.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Verify the fault is really bank 2 by watching both upstream sensors in live data - the faulty one will show abnormal behavior Tests: Failed upstream O2 sensor on bank 2 (most common)
  2. Check heater fuse and wiring, which often routes near hot exhaust on the firewall side Tests: Blown heater fuse shared with the bank 1 sensor circuit
  3. Compare bank 1 and bank 2 sensor behavior - the healthy bank is your reference Tests: Failed upstream O2 sensor on bank 2 (most common)
  4. Replace the sensor if the circuit tests good but the signal is bad Tests: Blown heater fuse shared with the bank 1 sensor circuit

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $130
Labor$75 – $180

O2 sensor replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0150 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Same job as bank 1, but bank 2 sensors are often harder to reach against the firewall.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →