P0140: O2 sensor circuit no activity detected, bank 1 sensor 2
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Drive safeEmissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever.
Can I drive with P0140?
Can I drive with a P0140 code?
Yes. P0140 doesn't make your car unsafe to drive on its own. Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever. Fix it when convenient rather than putting it off indefinitely — even a minor fault can turn into a bigger bill if the underlying cause gets worse.
How serious is P0140?
Low. WrenchFair rates this one “Drive safe” — the least serious of its three driveability ratings. It's a fix-on-your-schedule fault, not a same-day emergency. Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever.
Will P0140 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
The sensor behind the catalytic converter has gone silent. The car runs fine, but the computer can no longer confirm your emissions equipment is working.
VW/Audi note (VCDS): With the engine hot at idle, a working downstream sensor shows some voltage movement; a dead-flat 0.45V line means no activity.
Model notes: Always check that the sensor is actually plugged in before ordering parts, especially if exhaust work was done recently.
Key facts
P0140 means o2 sensor circuit no activity detected, bank 1 sensor 2. The sensor behind the catalytic converter has gone silent. The car runs fine, but the computer can no longer confirm your emissions equipment is working. WrenchFair's published fair-price range for this repair is $40–$130 parts and $75–$180 labor at independent shops.
WrenchFair rates P0140 a 2-of-5 DIY difficulty (“Quick diagnosis with live data, easy replacement.”) with a “Drive safe” driveability rating: Emissions and fuel-economy issue. Safe to drive - fix when convenient, but don't ignore it forever. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
failed emissions test
no drivability symptoms
Likely causes
Dead downstream O2 sensor (most common)
Broken wiring or corroded connector
Blown heater fuse
Sensor left unplugged after exhaust work
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 3 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Confirm flatline voltage in live data with the engine fully warm
Check heater fuse and connector Tests: Blown heater fuse
If wiring is intact, replace the sensor - downstream sensors are inexpensive relative to the diagnostic time Tests: Dead downstream O2 sensor (most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $130
Labor$75 – $180
O2 sensor replacement is the typical fix. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0140 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Quick diagnosis with live data, easy replacement.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →