P0087

P0087: Fuel rail/system pressure too low

For your specific vehicle: P0087 on a 2018–2020 Acura MDX · 2006–2011 BMW 3 Series · 2014–2019 Chevrolet Silverado 1500 · 2011–2016 Chevrolet Silverado HD · 2015–2020 Ford F-150 · 2011–2016 GMC Sierra HD
Show all 15 vehicles with this code

2018–2022 Honda Accord · 2016–2021 Honda Civic · 2017–2022 Honda CR-V · 2007–2008 Nissan Versa · 2019–2026 Ram 1500 · 2018–2024 Toyota Camry · 2019–2026 Toyota Corolla · 2019–2024 Toyota RAV4 · 2011–2014 Volkswagen Jetta

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Can I drive with P0087?

Can I drive with a P0087 code?

Short trips and gentle driving only, until you know the cause. Power loss under load is dangerous when merging - and repeated lean running damages the catalytic converter. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.

How serious is P0087?

Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Power loss under load is dangerous when merging - and repeated lean running damages the catalytic converter.

Will P0087 go away on its own?

The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.

Your engine isn't getting enough fuel pressure, especially under load. It'll hesitate and may go into limp mode. Usually the in-tank pump or a clogged filter.

VW/Audi note (VCDS): Graph specified vs actual rail pressure on a loaded pull - a widening gap under load names fuel delivery, not sensors.
Model notes: Log rail pressure actual vs specified under load - the gap under load is the diagnosis; both may look fine at idle. Verify the low-pressure side before condemning the high-pressure pump - the cheap side fails first.

Key facts

Symptoms

Likely causes

Owner notes linked to P0087: 15 across 2 repairs — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Log rail pressure actual vs specified under load Tests: Leaking injector dribbling rail pressure away
  2. Verify low-pressure side delivery volume before condemning the high-pressure pump Tests: Worn high-pressure fuel pump / cam follower (high mileage)
  3. Check fuel filter age and replace if unknown Tests: Clogged fuel filter
  4. Inspect the high-pressure pump cam follower for wear Tests: Worn high-pressure fuel pump / cam follower (high mileage)
  5. Pull spark plugs and look for fuel wash - a leaking injector drops rail pressure

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $500
Labor$150 – $500

Filter is cheap; in-tank pump is moderate; high-pressure pump costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0087 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Filter and LPFP are accessible; HPFP inspection is moderate.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →