C0916: Active Roll Stabilisation Rear Actuator Circuit
DIY difficulty 5/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonHandling is compromised — drive gently, avoid aggressive cornering, and fix it soon.
A suspension or chassis warning comes on. The car may lean more in corners than it used to — the active anti-roll system on the rear axle isn't working.
Key facts
C0916 means active Roll Stabilisation Rear Actuator Circuit. A suspension or chassis warning comes on. The car may lean more in corners than it used to — the active anti-roll system on the rear axle isn't working. WrenchFair's published fair-price range for this repair is $600–$2000 parts and $300–$700 labor at independent shops.
WrenchFair rates C0916 a 5-of-5 DIY difficulty (“Actuators are buried on the subframe and the parts are expensive — this is usually a shop job.”) with a “Diagnose soon” driveability rating: Handling is compromised — drive gently, avoid aggressive cornering, and fix it soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
chassis warning light on
more body roll in corners
active suspension unavailable message
Likely causes
actuator motor winding open
hydraulic supply pressure low (hydraulic type)
wiring fault
connector corrosion
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the actuator's power supply and connector. Tests: connector corrosion
2. For hydraulic types, check the supply pressure and fluid level. Tests: hydraulic supply pressure low (hydraulic type)
3. Inspect wiring along the subframe for damage.
4. Replace the actuator if power and hydraulics are good but it won't respond. Tests: actuator motor winding open
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$600 – $2000
Labor$300 – $700
Roll stabilization actuator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0916 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
5 of 5 — Actuators are buried on the subframe and the parts are expensive — this is usually a shop job.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →