Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStability assist is degraded — drive conservatively, especially in rain or snow.
Your stability or AWD warning light comes on. The car drives normally, but the torque-vectoring assist is offline.
Key facts
C0600 means active Yaw Control System Failure. Your stability or AWD warning light comes on. The car drives normally, but the torque-vectoring assist is offline. WrenchFair's published fair-price range for this repair is $200–$1600 parts and $150–$400 labor at independent shops.
WrenchFair rates C0600 a 4-of-5 DIY difficulty (“Usually a module or sensor issue — scan-tool diagnosis, and modules need programming.”) with a “Diagnose soon” driveability rating: Stability assist is degraded — drive conservatively, especially in rain or snow. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
stability control warning light on
awd warning light on
torque vectoring unavailable
Likely causes
one sensor input invalid (fix companion codes first)
yaw control module internal failure
wiring fault
low system voltage
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Read all chassis codes — repair companion sensor codes first. Tests: one sensor input invalid (fix companion codes first)
2. Check system voltage and the module's powers and grounds. Tests: low system voltage
3. Inspect the module connector and wiring.
4. If it still fails self-test alone, the module needs replacement and programming.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$200 – $1600
Labor$150 – $400
Yaw control module replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0600 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Usually a module or sensor issue — scan-tool diagnosis, and modules need programming.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →