Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBase braking works, but the brake-by-wire logic is degraded — get it diagnosed soon.
A brake warning comes on. The system can't properly separate manual and boosted braking modes.
Key facts
C05D5 means brake Master Cylinder Cut Off Valve. A brake warning comes on. The system can't properly separate manual and boosted braking modes. WrenchFair's published fair-price range for this repair is $300–$1200 parts and $200–$500 labor at independent shops.
WrenchFair rates C05D5 a 4-of-5 DIY difficulty (“Brake-by-wire hydraulics — diagnosis is electrical, but the valve is usually part of the hydraulic unit.”) with a “Diagnose soon” driveability rating: Base braking works, but the brake-by-wire logic is degraded — get it diagnosed soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake system warning light on
brake pedal feels odd
brake assist reduced
Likely causes
cut-off valve coil failed
wiring fault
valve sticking
module driver fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Command the valve with a scan-tool output test.
2. Check its wiring and connector for damage.
3. Measure the coil — an open or shorted coil means replacement.
4. Replace the hydraulic unit if the valve is internal, then bleed and calibrate.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$300 – $1200
Labor$200 – $500
Hydraulic unit replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C05D5 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Brake-by-wire hydraulics — diagnosis is electrical, but the valve is usually part of the hydraulic unit.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →