C05C3

C05C3: Brake Booster Motor A Supply Circuit

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

A brake warning comes on and the pedal gets much harder — the booster motor has lost its power feed.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Check the booster's high-current fuse and relay. Tests: blown high-current fuse
  2. 2. Measure supply voltage and ground right at the booster connector. Tests: corroded power connector
  3. 3. Trace the feed for breaks, shorts, or corrosion.
  4. 4. Repair the feed; if the feed is good, the booster itself has failed. Tests: faulty booster relay

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$20 – $1200
Labor$100 – $550

Supply wiring repair or brake booster replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C05C3 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Check the high-current feed before anything else — supply faults are often a fuse or corroded terminal.

Watch this repair on YouTube

Parts & tools

ABS / wheel-speed toolkit — what the job actually takes

Torque specs: Wheel-speed sensor bolts: typically 8–12 Nm. (Caliper bracket bolts are far tighter — 90–140 Nm — don’t confuse them.)

Pro tip: Inspect the tone ring/reluctor for cracks and debris first — the sensor itself is often innocent.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →