Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonBase braking works, but electronic brake assists are degraded — get it diagnosed soon.
Brake-system warnings come on. The pedal still stops the car, but the electronic brake assists are degraded.
Key facts
C055F means bSCM/EBBC Hydraulic Unit Performance. Brake-system warnings come on. The pedal still stops the car, but the electronic brake assists are degraded. WrenchFair's published fair-price range for this repair is $400–$1500 parts and $200–$500 labor at independent shops.
WrenchFair rates C055F a 4-of-5 DIY difficulty (“Internal to the hydraulic unit — diagnosis is electrical and scan-tool work; repair is the assembly.”) with a “Diagnose soon” driveability rating: Base braking works, but electronic brake assists are degraded — get it diagnosed soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
brake system warning light on
brake assist reduced
stability control disabled message
Likely causes
hydraulic unit internal fault
valve sticking from contaminated fluid
low system voltage
module driver fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Read all codes — fix sensor and voltage codes first. Tests: low system voltage
2. Check brake fluid condition; flush if contaminated. Tests: valve sticking from contaminated fluid
3. Run the hydraulic unit's output tests with a scan tool. Tests: hydraulic unit internal fault
4. If the actuator still won't respond, replace the hydraulic unit, then bleed and calibrate. Tests: hydraulic unit internal fault
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$400 – $1500
Labor$200 – $500
Brake hydraulic unit replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C055F ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Internal to the hydraulic unit — diagnosis is electrical and scan-tool work; repair is the assembly.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →