C0131

C0131: Master Cylinder Pressure Sensor Range/Performance

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor measuring your brake pedal pressure is sending readings the computer doesn't believe. Your brakes still work, but brake assist and stability control may be limited.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Check the brake fluid level first - low fluid skews pressure readings. Tests: low brake fluid skewing the reading - check the reservoir first
  2. 2. Watch the pressure sensor in scan tool live data while pressing the pedal: it should rise smoothly. Tests: master cylinder pressure sensor failed (often part of the booster or master cylinder…
  3. 3. Inspect the sensor wiring and connector for damage or corrosion. Tests: wiring fault to the sensor
  4. 4. If the signal is dead or stuck with good wiring, the sensor (often serviced with the booster or master cylinder) needs replacement. Tests: master cylinder pressure sensor failed (often part of the booster or master cylinder…

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $400
Labor$150 – $350

A pressure sensor or booster assembly repair, roughly $300-$600 installed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0131 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Fluid and wiring checks are DIY; the sensor is often buried in the booster assembly.

Watch this repair on YouTube

Parts & tools

ABS / wheel-speed toolkit — what the job actually takes

Torque specs: Wheel-speed sensor bolts: typically 8–12 Nm. (Caliper bracket bolts are far tighter — 90–140 Nm — don’t confuse them.)

Pro tip: Inspect the tone ring/reluctor for cracks and debris first — the sensor itself is often innocent.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →