C0016

C0016: Right Front Hydraulic Release Too Long

DIY difficulty 5/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car's ABS computer tried to work a brake valve inside the hydraulic control unit and it didn't respond correctly. Your normal brakes work fine, but ABS, traction control, and stability control are likely switched off.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Clear the code and re-scan after a short drive to confirm it is a hard fault, not a one-time glitch.
  2. 2. Check the brake fluid: dark, murky fluid is a classic cause of sticky valves. A full fluid flush is the cheapest first move. Tests: sluggish valve from old or contaminated brake fluid (flush first - it's cheap)
  3. 3. With a scan tool that has ABS bidirectional controls, try commanding the outlet valve on and off and listen/feel for a click. Tests: valve coil weakening inside the hydraulic control unit
  4. 4. Inspect the wiring and connector at the hydraulic control unit for corrosion or damage. Tests: valve coil weakening inside the hydraulic control unit
  5. 5. If the valve still won't respond, the fix is usually a remanufactured hydraulic control unit followed by a full brake bleed.
  6. 6. After replacement, bleed the brakes thoroughly and clear all ABS codes before the test drive.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$400 – $1400
Labor$300 – $700

A remanufactured hydraulic control unit with installation and brake bleed, roughly $800-$1,800 all-in. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for C0016 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

5 of 5 — Diagnosis is DIY-friendly, but the repair usually means a remanufactured hydraulic unit and a proper brake bleed.

Watch this repair on YouTube

Parts & tools

ABS / wheel-speed toolkit — what the job actually takes

Torque specs: Wheel-speed sensor bolts: typically 8–12 Nm. (Caliper bracket bolts are far tighter — 90–140 Nm — don’t confuse them.)

Pro tip: Inspect the tone ring/reluctor for cracks and debris first — the sensor itself is often innocent.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →