Community-sourced DIY repair guides for the 2021–2025 Toyota Sienna, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer-only — torque verification of the seatback bolts. Repair takes about 30 minutes per Toyota.
Typical time: “Repair takes about 30 minutes per Toyota.” — as written in the note. First-timers often take twice this.
Torque specs
Seatback bolts: verify — Dealer-only campaign; torque is applied to Toyota's spec in the remedy instructions.
Tips
NHTSA 25V086 / Toyota 25TA05 covers about 167,802 Sienna hybrids from 2021-2025: the bolts connecting the 60/40 third-row seat backs to the recliner plates may not have been torqued to spec, so the seats can fail FMVSS seating and head-restraint standards.
Toyota's own FAQ names the owner-visible symptom: a rattle-type noise from the third-row seats. Toyota estimates under 1% of recalled vans are actually affected, but the recall covers the full population.
The remedy is free: dealers check the seat-assembly bolt torque and retorque to spec, about 30 minutes. Owner letters went out in spring 2025; check the VIN on Toyota's site if you bought used.
Per precedent on this site, the value is knowing the documented free route before paying for anything — there is no owner repair here, just the dealer campaign.
Second-row seats, in the cabin — the slider latch area under the seat. The owner fix uses zip ties and requires no disassembly beyond accessing the latch.
Torque specs
N/A (rattle fix): verify — No torque-critical fasteners involved in the felt/zip-tie fixes.
Tips
The 4th-gen Sienna's second-row chairs develop a creaking or clicking rattle over lightly rough roads — owners trace it to the slider latch on the passenger-side seat, where metal rattles against metal.
The dealer path exists: one owner had the dealer add felt to take up the slack at the latch, and reports the fix is a known issue with a repair method in Toyota's TIS, covered under warranty. If your van is still under warranty, ask the dealer to check TIS for the second-row rattle repair.
The owner path: zip-tying the latch area eliminated about 98% of the rattle for one owner, leaving only a faint vibration on the worst road stretches. Cheap, reversible, and worth trying before a dealer visit.
Honest caveat: fix confirmations are owner- and dealer-report level from one long forum thread plus a corroborating dealer writeup shared from the 4th-gen owner group — no public TSB number is published for this specific rattle.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2021–2025 Toyota Sienna yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.