Community-sourced DIY repair guides for the 2008–2019 Toyota Highlander, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Check from the passenger side of the engine bay at the front timing cover. Oil here is frequently mistaken for flung CV-boot grease — the dye test below settles it.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
Timing cover / front cover fasteners: verify — Torque specs for timing-cover fasteners not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Settle seep-vs-leak before spending anything: add UV dye to the oil, clean the area, and re-inspect after a few hundred miles. One owner proved his 'timing cover leak' was actually a torn inner CV boot — grease flings into droplets that oil does not form.
Most of these are seeps, not gushers. Owners commonly run years at the seep stage with no driveway spots and no measurable consumption — monitor the dipstick weekly and only commit to the repair when it becomes a real leak.
Push the powertrain warranty if you are inside 5 years / 60,000 miles: a 2015 owner had the dealer reseal it at 57,000 miles. The job is engine-out and ran about $1,700 on the warranty ticket — out-of-warranty quotes run $5,000+.
Honest caveat: one owner's reseal leaked again about a year and a half later. The revised black RTV replaces the original grey, but this is not a guaranteed permanent fix — weigh that before paying out of pocket.
Do not confuse this with the 2GR-FE timing-cover weep already noted on the 3rd-gen Tacoma — same engine family, but this note covers the Highlander-specific diagnosis and warranty path.
2nd gen: the tailgate actuator motor lives inside the driver-side rear pillar behind interior trim. 3rd gen: the power struts are visible at the hatch hinges.
Torque specs
Liftgate actuator / strut fasteners: verify — Torque specs for liftgate hardware not confirmed from a forum source — confirm against factory service info before torquing.
Tips
Diagnose before buying parts: confirm the power back door is actually enabled (some years have an ON/OFF button in the glove box that gets bumped), and try the fob, the exterior switch, and the interior button separately — one dead input is a switch problem, all dead is the drive system. After any battery disconnect, manually close the hatch fully once to reinitialize the system.
2008-2013: the common failure is a stripped gear inside the tailgate actuator in the driver-side pillar. Gear-only repair kits (e.g. the TY0817460 gear) exist and cost a fraction of the full actuator assembly.
2014-2019: the power strut actuators fail — they get noisy, then the hatch stops moving. Replace them as a pair (OE numbers 68910-09130 / 68910-09120); the TRQ/1AAuto walkthrough does it with a 10mm socket, extensions, and thread locker.
Cheapest route is converting to manual struts with the factory brackets — owners have documented the six-part bracket list — but that is a downgrade, not a repair. One DIYer warns the cheapest aftermarket power struts fail fast; buy quality or OEM-pattern parts.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 705 complaints for the 2008–2019 Toyota Highlander. 2008 was the worst year (404 complaints). Most-reported areas: service brakes, steering, electrical system.
18E107000 (27/11/2018) — ELECTRICAL SYSTEM Fujian Wanda Automobile Glass Industry (Wanda) is recalling certain aftermarket Replacement Windshields sold for use in 2014-2018 Toyota Highlander vehicles. The windshields have an attached wire harness that water may leak into, possibly causing damage to the vehicle's Engine Control…
09E022000 (27/04/2009) — EQUIPMENT TOYOTA IS RECALLING 39,100 STAINLESS STEEL EXHAUST TIPS SOLD BY TOYOTA AS AN OPTIONAL ACCESSORY FOR USE ON MY 2008 HIGHLANDER AND HIGHLANDER HYBRID VEHICLES. DUE TO IMPROPER HEAT TREATMENT DURING THE MANUFACTURING PROCESS, THE ORIGINAL CLAMP USED TO SECURE…
10V023000 (27/01/2010) — VEHICLE SPEED CONTROL:ACCELERATOR PEDAL TOYOTA IS RECALLING CERTAIN MODEL YEAR 2008-2010 HIGHLANDER, MODEL YEAR 2009-2010 COROLLA, VENZA AND MATRIX PASSENGER VEHICLES. THE ACCELERATOR PEDAL CAN GET STUCK IN THE WIDE OPEN POSITION DUE TO ITS BEING TRAPPED BY AN UNSECURED OR INCOMPATIBLE DRIVER'S FLOOR…
16V775000 (24/10/2016) — ELECTRICAL SYSTEM:WIRING Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2016 Highlander vehicles manufactured May 26, 2016, to September 16, 2016. The brake fluid level sensor may not be connected to the wire harness, preventing the sensor from detecting…
15V689000 (22/10/2015) — VISIBILITY:POWER WINDOW DEVICES AND CONTROLS Toyota Motor Company (Toyota) is recalling certain model year 2009-2011 Tundra, Sequoia, Corolla, Corolla Matrix and Scion xB, 2008-2011 Highlander and Highlander Hybrid, 2007 Camry and Camry Hybrid, 2009 Camry and Camry Hybrid, 2006-2011 RAV4, 2006-2010 Yaris, and 2009-2010 Scion…
11V245000 (21/04/2011) — AIR BAGS TOYOTA IS RECALLING CERTAIN MODEL YEAR 2008 HIGHLANDER, HIGHLANDER HYBRID, AND MODEL YEAR 2007-2008 RAV4 VEHICLES. IN THE CURTAIN SHIELD AIRBAG (CSA) SYSTEM, THERE ARE TWO SENSORS IN THE AIRBAG SENSOR ASSEMBLY WHICH ARE DESIGNED TO DETECT VEHICLE ROLL ANGLE…
18 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2008–2019 Toyota Highlander yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.