Community-sourced DIY repair guides for the 2008–2009 Toyota Highlander, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
VVT-i rubber oil line (sudden rupture risk) Owner-verified(3.5L V6 (2GR-FE))
Look at the passenger side of the engine, down toward the firewall at the rear valve cover — the rubber section of the VVT-i oil feed line lives there.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
VVT-i oil line banjo bolts: 48 ft-lbs (per guide, verify) — A DIY guide states 48 ft-lbs for the banjo bolts — confirm against factory service info before torquing.
Tips
The rubber section of this oil line hardens with heat and can rupture without warning, dumping the engine's oil in seconds — a dealer tech on the forum called it a 'when, not if' failure on uncorrected early 2GR-FE cars. 2008 through early-2009 Highlanders are in the affected range.
Toyota ran a limited service campaign (LSC 90K) replacing the rubber line free at the dealer. If yours was 'done,' verify it: owners report dealers skipping the work or fitting the wrong part. The correct replacement carries a prominent yellow stripe — look for it at the passenger-side firewall.
The campaign only swaps the rubber section. For a keeper, the permanent fix is the all-metal line (Toyota part 15772-31030) — a Toyota master tech on JustAnswer and the Car Care Nut both recommend it, but the dealer will not install it under the campaign; it is owner-paid.
DIY is documented on video: banjo bolts at both ends with new copper washers (rear 90430-16016, front 90430-16017). Check your oil level religiously until this is addressed — this failure mode leaves no time to react.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 404 complaints for the 2008–2009 Toyota Highlander. 2008 was the worst year (404 complaints). Most-reported areas: service brakes, engine, air bags.
09E022000 (27/04/2009) — EQUIPMENT TOYOTA IS RECALLING 39,100 STAINLESS STEEL EXHAUST TIPS SOLD BY TOYOTA AS AN OPTIONAL ACCESSORY FOR USE ON MY 2008 HIGHLANDER AND HIGHLANDER HYBRID VEHICLES. DUE TO IMPROPER HEAT TREATMENT DURING THE MANUFACTURING PROCESS, THE ORIGINAL CLAMP USED TO SECURE…
10V023000 (27/01/2010) — VEHICLE SPEED CONTROL:ACCELERATOR PEDAL TOYOTA IS RECALLING CERTAIN MODEL YEAR 2008-2010 HIGHLANDER, MODEL YEAR 2009-2010 COROLLA, VENZA AND MATRIX PASSENGER VEHICLES. THE ACCELERATOR PEDAL CAN GET STUCK IN THE WIDE OPEN POSITION DUE TO ITS BEING TRAPPED BY AN UNSECURED OR INCOMPATIBLE DRIVER'S FLOOR…
15V689000 (22/10/2015) — VISIBILITY:POWER WINDOW DEVICES AND CONTROLS Toyota Motor Company (Toyota) is recalling certain model year 2009-2011 Tundra, Sequoia, Corolla, Corolla Matrix and Scion xB, 2008-2011 Highlander and Highlander Hybrid, 2007 Camry and Camry Hybrid, 2009 Camry and Camry Hybrid, 2006-2011 RAV4, 2006-2010 Yaris, and 2009-2010 Scion…
11V245000 (21/04/2011) — AIR BAGS TOYOTA IS RECALLING CERTAIN MODEL YEAR 2008 HIGHLANDER, HIGHLANDER HYBRID, AND MODEL YEAR 2007-2008 RAV4 VEHICLES. IN THE CURTAIN SHIELD AIRBAG (CSA) SYSTEM, THERE ARE TWO SENSORS IN THE AIRBAG SENSOR ASSEMBLY WHICH ARE DESIGNED TO DETECT VEHICLE ROLL ANGLE…
14V743000 (19/11/2014) — SEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2010-2011 Prius and Corolla, 2009-2011 Venza, 2006-2010 Avalon, 2007-2010 FJ Cruiser, 2005-2011 Sienna and Sequoia, 2006-2011 Tacoma 4x2 and 4x4, Camry, Highlander, Tundra 4x2 and 4x4, and 2007-2011 Rav4 and…
08V181000 (18/04/2008) — SEAT BELTS:REAR/OTHER TOYOTA IS RECALLING 90,189 MY 2008 HIGHLANDER AND HIGHLANDER HYBRID PASSENGER VEHICLES EQUIPPED WITH A THIRD ROW SEAT. THESE VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THE NON-DRIVER DESIGNATED…
13 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2008–2009 Toyota Highlander yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.