2017–2023 Tesla Model 3

Community-sourced DIY repair guides for the 2017–2023 Tesla Model 3, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

Front upper control arm squeak/creak Owner-verified (EV)

The front upper control arm ball joint sits above the steering knuckle behind the front wheel. Its rubber boot is reachable with the wheel on, though jacking the car gives much better access.

Typical difficulty: Moderate — based on 27 code guides for the suspension repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: owner forum · owner forum · owner forum · owner forum

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

What owners report

NHTSA recorded 451 complaints for the 2017–2023 Tesla Model 3. 2020 was the worst year (451 complaints). Most-reported areas: forward collision avoidance, unknown or other, vehicle speed control.

Counts are NHTSA complaints filed for these model years, via the NHTSA API. See data for all Model 3 years →

Recalls

21 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.

Factory service bulletins

We don't have factory bulletin data for the 2017–2023 Tesla Model 3 yet.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.