Community-sourced DIY repair guides for the 2022–2022 Rivian R1T, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Run a VIN recall check; if affected, get the free pedal replacement at a service center — the OTA patch alone is not the full fix.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Tips
NHTSA 23V-883 / Rivian FSAM 1342 (December 2023): 7,873 2022 R1T and R1S vehicles built June 10, 2021 to October 31, 2022 with an early-revision accelerator pedal from Precision Varionic. In extreme cabin heat, the pedal sensor can drift outside its dead band, so lifting your foot may not register as 0% applied — the truck can fail to enter auto-hold or park, and in extreme cases creep forward very slowly like an idling gas car.
Rivian's fix has two halves: an OTA software update that detects and neutralizes the drift (the company said nearly all affected trucks got it before the NHTSA filing), AND a free physical replacement of the pedal assembly. The software alone is not the complete remedy — affected trucks still need the revised pedal.
Rivian estimated only about 1% of the population has the defect, and reported no accidents or injuries. Owner action: check for open recalls on your VIN; if yours is in the population, book the free pedal replacement even if the truck behaves normally — the failure mode only shows up in extreme heat.
Listen for front-suspension vibration or noise; if the truck is a 2022, confirm 22V744 shows complete on its recall history.
Typical difficulty: Moderate — based on 27 code guides for the suspension repair area (an area-level estimate, not this exact job).
Tips
NHTSA 22V-744 / Rivian FSAM 997 (October 2022): 12,212 early R1Ts, R1Ss and EDVs — the fastener connecting the front upper control arm to the steering knuckle may not have been sufficiently torqued, and separation means loss of steering control. It covered nearly every vehicle Rivian had built to that point.
Warning signs from Rivian's own filing: vibration, unusual noise, or harshness from the front suspension, or a change in steering feel. Rivian logged 7 reports of the condition (no injuries) before recalling, and CEO RJ Scaringe emailed customers directly saying a fully-loosened nut was extremely rare but warranted urgency.
Free remedy: the service center inspects and, if needed, tightens the steering-knuckle fastener to the correct tolerance — a quick visit, offered at no charge. Any used 2022 R1T must show this recall completed on its NHTSA history; it is non-negotiable given what a separated knuckle means.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2022–2022 Rivian R1T yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.