Community-sourced DIY repair guides for the 2021–2023 Ram 3500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer-only recall repair — free relay replacement (RamCares says about half an hour). The value is knowing the fire risk exists with the ignition OFF and parking outside, away from structures, until the relay is replaced.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Typical time: “Dealer-only recall repair — free relay replacement (RamCares says about half an hour).” — as written in the note. First-timers often take twice this.
Torque specs
No fasteners involved: verify — Dealer recall — relay swap under the hood; no torque specs apply.
Tips
The defect is electrical, not the mechanical grid-heater BOLT: the Generation 1 solid-state intake heater grid relay (part 68444169AB, supplier Eberspaecher Controls) can develop an internal short with the ignition on OR off, and the short can set the engine compartment on fire.
Park-outside recall — FCA's own instruction: do not park these trucks inside buildings or structures, or near other vehicles, until the relay is replaced. One NHTSA complaint describes a 2022 Ram 3500 catching fire under the hood with the ignition off, after the 13A relay replacement had already been performed in March 2025.
Coverage: certain 2021-2023 Ram 2500/3500 pickups and 3500/4500/5500 cab chassis with the 6.7L Cummins (sales codes ETN, ETL, ETM), built roughly August 2020 through February 2023. FCA campaign 13A, NHTSA 23V-060, announced February 9, 2023 — 302,067 vehicles (88,423 of them Ram 3500 pickups).
This is the THIRD round on this relay: Y08 (21V-163, March 2021) and Y76 (21V-798, October 2021) came first, and 23V-060 explicitly supersedes 21V-798. If you had the earlier relay work done, you still need to go back — the owner letter says trucks previously remedied under Y08/Y76 must be brought in again.
The fix is a Generation 2 internally fused relay, installed free. It was a phased rollout (2023s first, April 2023; then 2022s, then 2021s), and RamCares told owners the job takes about half an hour once the part is in stock — owners report dealers now generally have the relays.
Do not confuse this with the grid-heater bolt failure (P2609, bolt drops into cylinder #6) — different part, different failure, different campaign. A truck can be subject to both.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2021–2023 Ram 3500 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.