Community-sourced DIY repair guides for the 2019–2019 Ram 3500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Dealer TSB/RRT repair — free under warranty provisions (released as Rapid Response Transmittal 19-100 with a loaded VIN list). The value is knowing the 30-second PTO dropout means the diode harness was never installed, and that the underlying voltage spike can permanently kill the ECM.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
Aux fuse box bolts: verify — Two 10mm bolts retain the aux fuse box behind the driver's-side battery (per Ram Body Builder doc) — torque spec not published in the TSB; verify against factory service info.
Tips
Applies to 2019 (DD) Ram 3500 Cab Chassis built May 23, 2018 through August 5, 2019 with PTO Prep (sales code LBN) and left-side PTO (LBV). The F790 circuit that monitors the PTO hot-shift solenoid power (F607) is vulnerable to a voltage spike — and Ram's own body-builder guide says that spike causes ECM damage that is not repairable.
The symptom signature: the PTO runs about 30 seconds then shuts off with the PTO LED flashing (2019 trucks), or the PTO is simply inoperative. The technician may find DTC P1123-00 (PTO System Performance).
The fix is a PTO diode jumper harness installed by the dealer under TSB 08-121-19 (also released as RRT 19-100, December 6, 2019). Trucks built after August 5, 2019 got the protection at the factory — if your early-2019 cab chassis never went back to the dealer, assume it never got the diode.
Before condemning anything: Ram documents a second, simpler failure — the F790 circuit can break where it connects under the auxiliary fuse box behind the driver's-side battery (two 10mm bolts hold the box). A broken dark-blue wire with a pink tracer there is the root cause on some trucks.
Ask the dealer to check STAR online case 1918000009 (diode never installed) and S1608000300 (recall T79 not completed to the last step — another documented cause of PTO dropout right after dealer service).
Cab-chassis-only issue — pickup 3500s don't have the PTO provision wiring, so this never applies to a regular pickup bed truck.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
We don't have factory bulletin data for the 2019–2019 Ram 3500 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.