Community-sourced DIY repair guides for the 2013–2024 Ram 3500, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
DEF system fault / no-restart countdown Owner-verified(6.7L Cummins Turbo Diesel)
Driveway diagnosis with a scan tool or AlfaOBD. Injector cleaning is driveway-level; DEF pump replacement is an intermediate job.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Tips
The failure mode owners dread: a 'Service DEF System — See Dealer' message with a countdown, ending in 'engine will not restart in X miles.' Take it seriously before the last miles.
Owner-confirmed fixes, in order of cheapness: clean crystallized DEF off the dosing injector, reset the DEF fluid level with AlfaOBD and extend the SCR mileage, or replace the DEF pump.
DEF crystallizes when the truck sits or the fluid is old or contaminated — buy from high-turnover pumps, keep the tank reasonably full, and don't store DEF jugs for months.
A 13-year 6.7L Cummins owner review documents a DEF pump failure as one of the few real failures the truck had — the pump is the wear item of the system.
AlfaOBD with an OBDLink adapter is the owner-standard way to read SCR/DEF faults and perform fluid-level resets on these trucks; a generic code reader usually cannot.
Do not just clear the message and keep driving — the countdown continues and the truck will refuse to restart at zero. Diagnose the actual fault first.
Aisin AS69RC fluid and filter service (30k/60k) Owner-verified(6.7L Cummins Turbo Diesel)
Driveway service — the Aisin pan has a drain plug (19mm) and the dipstick tube is your fill point. The only genuinely awkward part is the four rear pan bolts hidden above the transmission crossmember.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Aisin transmission pan bolts: verify — Snug in a crisscross pattern — confirm the spec against factory service info; over-torquing distorts the pan and causes leaks.
Tips
The Aisin AS69RC was only ever fitted to the Ram 3500 pickup (never the 2500) — if your truck has the High Output 6.7L Cummins, this is your transmission. The Aisin dipstick is on the driver (cold) side of the engine; the 68RFE dipstick is on the passenger (hot) side.
The owner-verified rhythm from CumminsForum: drain & fill at 30,000 miles, then drop the pan and replace the sump filter plus fluid at 60,000, then repeat (90k drain & fill, 120k pan drop). A drain & fill takes about 7.2 quarts; a pan drop with filter takes roughly 9-10 quarts. Buy Mopar ASRC fluid (quart part 05189966AB) — owners report 8 quarts covers a drain & fill.
Do NOT use generic ATF. The Aisin calls for ASRC-spec fluid (Aisin T-IV / JWS 3309 chemistry); owners who asked report Mobil ATF 3309 as the commonly used equivalent. The wrong fluid is the fastest way to ruin shift quality in this transmission.
The job's one curse: the four rearmost pan bolts sit directly above the transmission crossmember. Owners get them two ways — drop/pivot the crossmember (floor jack under the transfer case, three mount nuts off, pivot the crossmember down), or fish the bolts out with a piece of vinyl tubing as shown in the DIY video. Budget extra time here on your first service.
After refilling, expect the check engine light to stay on: restart the truck about five times, idling in Park each time, and do NOT shift out of Park until the light goes out — owners who shifted early report a violent bang engaging gear. Check the dipstick at operating temperature (HOT crosshatch is 167°F) and do not overfill.
When the old sump filter comes off, check that its large O-ring came off with it and is not stuck up inside the valve body — and confirm the new filter's O-ring is seated on its snout before installation. A pinched or missing O-ring means pressure problems.
Dealer pricing owners report is around $650 for the 60k service; DIY with Mopar filter, gasket, and 3 gallons of ASRC fluid runs under $300. The sump filter part number owners cite is Mopar 68224232AA.
Dual fuel filter service — chassis separator + engine-bay filter, water drain Owner-verified(6.7L Cummins I6 (ISB))
Driveway hour — socket for the filter housings, catch pan (the rear filter sits over the driveshaft and will spill), new O-rings; cycle the key to prime, then check for leaks.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Typical time: “The dealer charges around $500 for this service; DIY is under $150 in parts and about an hour.” — as written in the note. First-timers often take twice this.
Tips
Every 6.7 since 2013 runs two fuel filters: a chassis-mounted fuel/water separator (under the bed, above the driveshaft) and an engine-bay final filter. Both share the same 15,000-mile/12-month interval — replacing only one is a half-done job. The 2013-2018 rear filter is a spin-on canister; 2019+ switched to a drop-in cartridge in a reusable plastic housing. The designs are not interchangeable, so buy by year.
The separator is your high-pressure pump's bodyguard: water strips the lubricating film inside the pump and turns a $100 filter job into a five-figure fuel system. Drain the separator at every oil change and immediately if the Water-in-Fuel light comes on — do not wait for the light if you buy fuel from low-turnover stations.
Prime before starting: cycle the key to Run (not Start) several times so the electric pump fills the housings, then start and check for leaks. The truck may crank a few extra revolutions on the first start while air purges — that is normal.
Buy genuine Mopar or Fleetguard filters — counterfeit fuel filters are a real problem on this platform and a fake filter's micron rating is fiction. The dealer charges around $500 for this service; DIY is under $150 in parts and about an hour. Reset the fuel-filter life monitor in the cluster afterward or the reminder will nag you.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 294 complaints for the 2013–2024 Ram 3500. 2016 was the worst year (134 complaints). Most-reported areas: engine, fuel/propulsion system, steering.
23V799000 (28/11/2023) — STEERING:STEERING CONTROL MODULE Chrysler (FCA US, LLC) is recalling certain 2023 Ram 1500 Classic, Ram 3500 Classic, 3500 Cab Chassis, 2023-2024 Ram 2500, 4500/5500 Cab Chassis, and Ram 3500 vehicles. The steering column control module may cause the high beams to activate when…
20V511000 (27/08/2020) — ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION Chrysler (FCA US LLC) is recalling certain 2019-2020 Ram 3500, 4500 and 5500 cab chassis built with a Cummins 6.7L High Output engine. Inadequate warmup protection can cause a lack of oil film on the engine connecting rod bearings while…
18V486000 (27/07/2018) — STRUCTURE:BODY:TAILGATE Chrysler (FCA US LLC) is recalling certain 2015-2017 RAM 1500, 2500, and 3500 pickup trucks equipped with a power locking tailgate and either a 5 foot, 7 inch or 6 foot, 4 inch bed. The tailgate actuator limiter tab may…
21V398000 (27/05/2021) — WHEELS:LUGS/NUTS/BOLTS/STUDS Chrysler (FCA US, LLC) is recalling certain 2012-2021 RAM 3500, 3500 Cab Chassis, 4500 Cab Chassis, and 5500 Cab Chassis vehicles. Incorrect information in the Service and Owner's Manuals may cause the flanged lug nuts to be over-tightened, which could…
22V035000 (27/01/2022) — VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES Chrysler (FCA US, LLC) is recalling certain 2019-2020 Ram 2500 and Ram 3500 vehicles, Ram 3500 Cab Chassis, 4500 Cab Chassis, 5500 Cab Chassis and 3500 Cab Chassis with a gross vehicle weight rating (GVWR) of less than 10,000 lbs…
19V021000 (25/01/2019) — STEERING:LINKAGES:DRAG:LINK:CONNECTION Chrysler (FCA US LLC) is recalling certain 2013-2018 Ram 3500 and 2014-2018 Ram 3500 Chassis Cab and Ram 2500 vehicles. The outboard steering linkage jam nut may loosen, allowing one end of the drag link to separate.
28 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2013–2024 Ram 3500 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.