2021–2022 Peterbilt 579

Community-sourced DIY repair guides for the 2021–2022 Peterbilt 579, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

Hill Start Assist valve may chafe the rear brake hose — loss of rear brake signal (21V-648 / PACCAR 21PBJ) Factory-documented (12.9L PACCAR MX-13 diesel (405–510 hp), Cummins X15 diesel (400–605 hp))

Dealer-only recall repair — free at any Peterbilt dealer. Owner-side value: the HSA valve sits too close to the rear axle: vibration wears the rear brake hose until the rear brake signal is lost — on 2021-2022 579s, inspect the clearance, not just the hose.

Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: NHTSA recall record 21V648 / PACCAR 21PBJ (NHTSA API) · NHTSA Recall 21V648 (oemdtc)

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

What owners report

No NHTSA complaint data in our records for the 2021–2022 Peterbilt 579 specifically. See NHTSA data for all 579 years →

Factory service bulletins

We don't have factory bulletin data for the 2021–2022 Peterbilt 579 yet.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.