2011–2011 Peterbilt 367

Community-sourced DIY repair guides for the 2011–2011 Peterbilt 367, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.

Owner-verified repair guides

EGR valve actuator output shaft seal may delaminate — oil leak (10V-453 / PACCAR E008R) Factory-documented (Cummins ISX15 diesel (400–605 hp), 12.9L PACCAR MX-13 diesel (405–510 hp))

Dealer-only recall repair — free at any Peterbilt dealer. Owner-side value: a supplier seal defect: on 2011 367s the EGR valve actuator's output shaft seal can delaminate and leak oil — an EGR-area oil leak on a 2011 367 is this campaign before it's a turbo seal.

Typical difficulty: Moderate — based on 83 code guides for the egr repair area (an area-level estimate, not this exact job).

Torque specs

Tips

Sources: NHTSA recall record 10V453 / PACCAR E008R (NHTSA API) · NHTSA Recall 10V453 (oemdtc)

No owner reports yet — fixed this yourself? tell us how

Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

What owners report

No NHTSA complaint data in our records for the 2011–2011 Peterbilt 367 specifically. See NHTSA data for all 367 years →

Factory service bulletins

We don't have factory bulletin data for the 2011–2011 Peterbilt 367 yet.

Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.

Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.