Community-sourced DIY repair guides for the 2009–2014 Nissan Murano, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
The steering lock unit lives on the steering column. Replacement is a column-area job — owners report $800-$1,100 at the dealer. The interim release trick (below) is for getting a stranded car started, not a repair.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
Torque specs
Steering lock unit fasteners: verify — Torque specs for the steering lock unit not confirmed from a forum source — confirm against factory service info before torquing.
Tips
The signature is unmistakable: press the start button and nothing happens — no crank, no start — often with the Intelligent Key warning light on. Shaking or turning the steering wheel sometimes gets it going once, but it comes back. This is the electronic steering column lock failing to release, not a dead battery or bad fob.
Owners on CarComplaints (2009 and 2010 Muranos) report the same story repeatedly: intermittent no-starts for months, dealers finding nothing until it fails hard, then a ~$1,100 steering column lock replacement. One owner notes Nissan extended the warranty for this exact failure on the Altima and Maxima but NOT on the Murano — check for any current coverage, but do not assume it exists.
A documented interim trick from an owner forum: with the tilt-lock lever released, shake the steering wheel firmly up and down while pressing start — this can jar the stuck lock pin free enough to get the car started and to a shop. It is a roadside workaround, not a fix.
Per a Nissan tech's explanation of the start sequence: the car requests the steering lock to release before it will turn on the ignition and send the start signal. If the lock is stuck, the whole chain stops — so a no-crank with lights and fans working points at the lock, not the starter.
Act at the first intermittent no-start. Once the lock fails in the engaged position you are stranded with no roadside fix — a tow is the only option at that point.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 135 complaints for the 2009–2014 Nissan Murano. 2012 was the worst year (135 complaints). Most-reported areas: power train, air bags, unknown or other.
12V068000 (22/02/2012) — TIRES:PRESSURE MONITORING AND REGULATING SYSTEMS NISSAN IS RECALLING CERTAIN MODEL YEAR 2012 MURANO AND ROGUE VEHICLES, MANUFACTURED FROM NOVEMBER 23, 2011 THROUGH JANUARY 11, 2012. DURING ASSEMBLY, THE TIRE PRESSURE MONITORING SYSTEM (TPMS) WAS NOT ACTIVATED. THUS, THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS…
1 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2009–2014 Nissan Murano yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.