Community-sourced DIY repair guides for the 2021–2025 Kenworth T680, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Bendix EC-80 ABS ECU may misprocess commands from PLC signal noise — loss of ABS/ESC (24V-915 / PACCAR 24KWL) Factory-documented(12.9L PACCAR MX-13 diesel (405–510 hp), Cummins X15 diesel (400–605 hp))
Dealer-only recall repair — free at any Kenworth dealer. Owner-side value: if the ABS, traction control, or collision-mitigation warnings misbehave on a 2021-2025 T680, this is the first campaign to rule out — it is the largest PACCAR recall of the decade (220,764 trucks across Kenworth and Peterbilt) and the Kenworth filing of the same defect covered on the Peterbilt 579 in run #331.
Typical difficulty: Moderate — based on 265 code guides for the brake repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer reprogram only; no owner repair. Free at any Kenworth dealer.
Tips
Electrical noise on the power-line carrier can make the Bendix EC-80 ECU misprocess commands or stop functioning — ABS, automatic traction control, ESC, active cruise, and collision mitigation can all drop out with it.
The NHTSA record lists 2021-2025 T680, T880, W990, W900B, T800B, T380, T480, T280, and C500B Kenworths — the same defect the store already carries for the Peterbilt 579 (24V915) and the International LT/RH (24V818).
Dealer remedy is a free ECU software reprogram (owner letters mailed Feb 3, 2025). Kenworth customer service: 1-425-828-5888.
Improperly crimped connectors in the gear shifter stalk — loss of shifter-to-transmission communication (24V-190 / PACCAR 24KWE) Factory-documented(12.9L PACCAR MX-13 diesel (405–510 hp), Cummins X15 diesel (400–605 hp))
Dealer-only recall repair — free at any Kenworth dealer. Owner-side value: 70,509 trucks (the broader PACCAR filing topped 100,000 with Peterbilt). If the dash throws a transmission fault and the truck strands itself after a stop, the stalk connectors — not the transmission — are the suspect.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
No owner-serviceable fasteners: verify — Dealer repair only; no owner repair. Free at any Kenworth dealer.
Tips
Right-hand shifter stalk connectors may have been improperly crimped, causing loss of communication between the shifter and the transmission — the vehicle can become disabled after coming to a stop.
A transmission fault on the dash display is the tell; dealers inspect and replace the gear shifter assembly free of charge.
Kenworth filing 24KWE — same defect as the Peterbilt 579 note in run #331.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 3 complaints for the 2021–2025 Kenworth T680. 2024 was the worst year (3 complaints). Most-reported areas: power train, electrical system, vehicle speed control.
25V436000 (26/06/2025) — EXTERIOR LIGHTING:LIGHTING CONTROL MODULE:SOFTWARE PACCAR Incorporated (PACCAR) is recalling certain 2024-2026 Kenworth T480, T680, T880, W990, Peterbilt 520, 536, 537, 548, 567, 579, 589, 2025 Kenworth T180, Peterbilt 535, 2025-2026 Kenworth T280, T380 and L770 vehicles. The tail brake light, upper and lower beam…
24V044000 (25/01/2024) — STEERING PACCAR Incorporated (PACCAR) is recalling certain 2024-2025 Kenworth T280, T380, T480, T680, T880, L770, W990, and 2024-2025 Peterbilt 389, 520, 535, 536, 537, 548, 567, 579, 589 trucks. The steering gear assemblies may have been assembled incorrectly with fewer recirculating…
25V181000 (24/03/2025) — ELECTRICAL SYSTEM:PROPULSION SYSTEM PACCAR Incorporated (PACCAR) is recalling certain 2022-2025 Peterbilt 520, 579, and 2021-2025 Kenworth T680 trucks. The high voltage (HV) contactors may open, causing a sudden loss of high voltage and a loss of drive power.
24V145000 (23/02/2024) — SERVICE BRAKES, AIR:SUPPLY:RESERVOIR/TANK PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2009-2024 Kenworth T800, 2009-2020 Kenworth T370, 2014-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, and 2009-2019 Kenworth W900 vehicles. The air…
24V190000 (20/03/2024) — POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT PACCAR Incorporated (PACCAR) is recalling certain 2021-2024 Peterbilt 365, 367, 389, 535, 536, 537, 548, 567, 579, and 2021-2025 Kenworth T180, T280, T380, T480, T680, T880 and W990 trucks. The right-hand gear shifter stalk connectors may have been improperly crimped…
24V915000 (10/12/2024) — SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE PACCAR Incorporated (PACCAR) is recalling certain 2021-2025 Peterbilt and Kenworth vehicles, equipped with Bendix EC80 Advanced Electronic Control Units (ECU). Please see the recall report for a complete list of models. Electrical noise and low signal to the power line…
7 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2021–2025 Kenworth T680 yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.