Community-sourced DIY repair guides for the 2015–2016 Jeep Renegade, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
Owner-verified repair guides
Trailer hitch recall — hitch attached with one fastener per side (16V545000 / S62) Factory-documented(2.4L Tigershark I4, 1.4L MultiAir Turbo I4)
Dealer-performed recall (free fastener install). Owners with the factory hitch can check for missing bolts, but the recall itself is dealer work.
Torque specs
Trailer hitch fasteners (recall work): verify — Dealer-performed recall; confirm spec against factory service info before torquing hardware yourself.
Tips
Some 2015-2016 Renegades with the factory optional trailer hitch package were assembled with only one fastener per side instead of three, so the hitch can separate from the vehicle while towing.
Recall S62 (NHTSA 16V545000) covers 8,581 vehicles built August 25, 2014 - June 25, 2016 with the original-equipment Class III receiver hitch (sales code XFJ).
The free dealer fix is installing two additional fasteners per side. If you tow with an affected Renegade, do not keep towing on the single-fastener mount — a separated hitch means a separated trailer.
Only Renegades with the factory-installed hitch package are covered; an aftermarket hitch is not part of this campaign.
Passenger motor mount — vibration at idle in gear Owner-verified(2.4L Tigershark I4)
Support the engine from below with a jack and a wide block of wood on the oil pan, then unbolt and swap the mount. The passenger-side mount is reachable from the wheel well / engine bay without dropping anything major.
Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).
Torque specs
Motor mount fasteners: verify — Mount-to-block and mount-to-frame torque values not confirmed from a forum source — confirm against factory service info before torquing.
Tips
The signature symptom is a buzzing vibration felt through the wheel and floor when idling in Drive at a stoplight that fades as soon as you shift to Neutral or Park — that points at the passenger-side engine mount, not the transmission.
The original 2015-2016 mount design was deficient; Mopar redesigned it in early 2017. One owner swapped both original-design mounts for the redesigned parts at ~51,000 miles for $198 and the vibration went away, and the DIY video author confirms the redesigned part is the one to buy.
Don't chase this through spark plugs, transmission fluid, or idle-relearn first — two independent Renegade owners documented the same fix and the same failed-original-design root cause.
Support the engine with a jack and wood block under the oil pan and lift just enough to unload the mount studs; the mount slides out sideways once the tension is off.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 430 complaints for the 2015–2016 Jeep Renegade. 2016 was the worst year (430 complaints). Most-reported areas: engine, electrical system, unknown or other.
16V545000 (20/07/2016) — TRAILER HITCHES Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Jeep Renegade vehicles manufactured August 25, 2014, to June 25, 2016, equipped with a factory-installed optional trailer hitch package. The trailer hitch assembly may have been attached with only a…
16E013000 (18/02/2016) — SUSPENSION:REAR Daystar Products International, Inc. (Daystar) is recalling certain aftermarket replacement rear control arm brackets included in Daystar's 2015-2016 Jeep Renegade 1.5" spacer kit, part KJ09168BK, shipped from Daystar to distributors between October 27, 2015 and November 5, 2015. The affected…
2 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2015–2016 Jeep Renegade yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.