Community-sourced DIY repair guides for the 2020–2021 Jeep Gladiator, plus NHTSA complaints and recalls sliced to these model years. Every guide below comes from real owner-community procedures with sources.
The fix is free at the dealer — no driveway work involved. The tell is a burnt-clutch smell or a shudder/jerk on takeoff; a fractured plate can also spray debris or open the transmission case, which is why the recall exists. When you book, cite NHTSA 20V124 (W12) and 21V028 (Y01) and ask for the software update plus the wire-harness reroute inspection. The 2021 recall added an engine-torque-derate software change that limits power when the clutch gets hot — it protects the plate, but owners who tow heavy on the manual should know the derate can feel like a sudden power cut on grades.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
Torque specs
Clutch replacement: verify — Dealer recall work — no owner-confirmed torque values from forum sources; confirm against factory service info.
Tips
The pressure plate can overheat and fracture, which increases fire risk and can throw debris onto the road — this is the recall to get done, not a DIY fix.
2020 trucks got W12 (harness reroute + clutch inspection/replacement); the 2020–2021 run got Y01 (software that cuts engine torque when clutch temps spike). Both are free.
Burnt-clutch smell before a failure was reported — if you smell it, park it and call the dealer rather than driving through it.
If you hear water sloshing inside the hardtop when you brake or turn, the rear glass seal is the prime suspect — water pools in the top itself. The owner DIY is a silicone vacuum hose pressed into the gap around the rear glass to seal it, and owners report it stops the leak where a dealer glass replacement only fixed it temporarily. The dealer path is a full rear-glass replacement under warranty (the seal is bonded to the frame, so they replace the whole window). Before either fix, pull the hardtop off, flip it upside down, and shake the water out — owners who skipped this ended up with water still sloshing after the repair.
Torque specs
Rear glass replacement: verify — Dealer warranty work — no owner-confirmed torque values from forum sources; confirm against factory service info.
Tips
Don't assume it's the freedom panels or door seals — on these trucks the classic symptom is water sloshing inside the hardtop itself, which points at the rear glass.
A cracked or separated seal means water gets inside the top where it can freeze and crack it in winter — push for a glass replacement under warranty rather than a reseal.
Some owners found their dealer replaced the whole top on early trucks; if the top itself is waterlogged, ask for that.
Difficulty lines above are area-level estimates from code guides for that repair area, not the exact job; times are quoted verbatim from the notes themselves — first-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
What owners report
NHTSA recorded 483 complaints for the 2020–2021 Jeep Gladiator. 2020 was the worst year (483 complaints). Most-reported areas: electrical system, steering, power train.
19V636000 (29/08/2019) — POWER TRAIN:DRIVELINE:DRIVESHAFT Chrysler (FCA US LLC) is recalling certain 2020 Jeep Gladiator vehicles. The rear driveshafts may have been incorrectly assembled without grease in the monoblock joint.
21V028000 (28/01/2021) — POWER TRAIN:CLUTCH ASSEMBLY Chrysler (FCA US, LLC) is recalling certain 2018-2021 Jeep Wrangler and 2020-2021 Jeep Gladiator vehicles equipped with manual transmissions. The clutch pressure plate may overheat and fracture.
20V580000 (24/09/2020) — SEAT BELTS Chrysler (FCA US LLC) is recalling certain 2019 Jeep Wrangler and Ram 2500, 2019-2020 Ram 1500 and 2020 Jeep Gladiator vehicles. In the event of a crash, a front seat belt retractor may not properly slow the occupant's forward movement…
23V116000 (23/02/2023) — POWER TRAIN:CLUTCH ASSEMBLY Chrysler (FCA US, LLC) is recalling certain 2018-2023 Jeep Wrangler, and 2020-2023 Jeep Gladiator vehicles equipped with manual transmissions. The clutch pressure plate may overheat and fracture.
20V191000 (10/09/2020) — BACK OVER PREVENTION: SENSING SYSTEM: CAMERA Chrysler (FCA US LLC) is recalling certain 2020 Jeep Gladiator and Jeep Cherokee, 2019-2020 Ram 1500 Pickup, Ram 2500 Pickup, Ram 3500 Pickup, Chrysler Pacifica, Dodge Durango, Jeep Grand Cherokee, Jeep Wrangler, and Jeep Renegade and 2019 Dodge Challenger vehicles…
24V652000 (05/09/2024) — ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL Chrysler (FCA US, LLC) is recalling certain 2020-2024 Jeep Gladiator and 2018-2024 Jeep Wrangler vehicles. The instrument panel cluster may experience an internal short circuit and fail. As such, these vehicles fail to comply with the requirements of Federal Motor…
7 recall campaigns touch these years. Check your VIN at nhtsa.gov/recalls.
Factory service bulletins
We don't have factory bulletin data for the 2020–2021 Jeep Gladiator yet.
Counts are deduplicated NHTSA manufacturer communications for these model years, via the NHTSA safety-issues API. Look up bulletins for your exact VIN at nhtsa.gov/recalls under Manufacturer Communications.
Torque specs marked “verify” were not published with a citable factory source — confirm them against the factory service manual for your exact engine before tightening. A trouble code does not prove a part needs replacement.